Microstructure and Ion Exchange in Stearic Acid Langmuir-Blodgett Films Studied by Fourier Transform Infrared-Attenuated Total Reflection Spectroscopy

Fourier transform infrared-attenuated total reflection (FTIR-ATR) spectra have been recorded of 11-layer Langmuir-Blodgett (LB) films of stearic acid deposited at various surface pressures (0.1, 15, and 35 mN/m), and the molecular orientation angles were evaluated quantitatively, which supplied insight into the molecular order with the alkyl chains tightly packed like crystal in the LB films deposited at the zero and higher surface pressures. These experimental results indicate that, in the Langmuir film as the precursor of LB films, stearic acid molecules self-aggregate to form two-dimensional crystalline domains already even at the zero surface pressure, which results in the inhomogeneity of monolayer. The analysis of dependence of nu(C=O) intensity on the surface pressure, surface density, and subphase temperature leads to the conclusion that the defects in LB films originate from the Langmuir film and be conserved upon deposition. Annealing below 50 degrees C and cooling could improve the monolayer homogeneity, and thus a defect-free or low-defect LB films can be deposited. Furthermore, ion exchange conducted in the LB films, on the other hand, confirms the existence of structure defects in LB films of stearic acid. The polar plane microstructure, lateral transport along the polar planes and the coordination types of stearic acid/cation system may be the rate-limiting process. The results have implication on the possible uses of stearic acid LB films as ion-exchange materials or sensors. Copyright 2001 Academic Press.     

Determination of Gossypol in Trace Level by Flow Injection Analysis with Chemiluminescence Detection

Gossypol, [1, 1′, 6, 6′, 7,7′-hexahydroxyl-5,5′-diisopropyl-3,3′-dimethyl-(2,2′-binaphtha- lene)-8,8′-dicarboxaldehyde] is a polyphenolic yellow compound naturally occurring in various parts of cotton plants1. The compound has been associated with     

HCN及其氢加成物分子间氢键问题的量子化学研究

采用量子化学(MNDO、CNDO/2)方法,探讨了HCN、H_2CNH和H_3CNH_2分子间的N…H-C氢键的构成。计算表明:HCN-HCN分子间氢键作用较强,支持了实验结果。HCN及其氢加成物H_2CNH、H_3CNH_2等分子间的氢键作用依次减弱,其随C≡N、C=N、C-N的差异而变化,碳氮链中氮原子的作用是构成N…H-C型氢键的一个决定性因素。     

α－芳甲酰基烯酮二硫缩醛的新合成方法

以碳酸钾为碱，芳甲酰丙酮（１）与二硫化碳、卤代烃反应得到２－乙酰基－２－芳甲酰基烯酮硫代缩醛（２），２在乙硫醇钾作用下脱乙酰基生成标题化合物（３）。１→３的转化具有反应条件温和、产物产率高及对３中各种缩醛基均可通用等特点。     

刚性链嵌段共聚物研究 Ⅱ．含双酚S的聚醚醚酮共聚物合成与性能

series of multiblock copolymers composed of polyetheretherketone (PEEK) and 4, 4'-dihydroxydiphenylsulfone (DHDPS) were synthesized by polycondensation. The property of copolymers were characterics by DSC, IR, WAXD and TGA. The results indicate that the T_g of copolymers increases with increasing DHDPS content' When the DHDPS content of the copolymers is less than 22% (the average degree of polymerization of PEEK oligomers is more than 6), the copolymers are Crystalline polymers. The highest T_g of the Crystalline copolymers is 160℃,the lowest T_m is 304℃.     

化学蒸气沉积硅氧化合物调变HZSM－5沸石的研究

本文研究了正硅酸乙酯分别在无胺法和有胺法制得的ＨＺＳＭ－５沸石上的沉积过程，并用吸附，ＮＨ３－ＴＰＤ及异丙醇探针反应等手段表征了沉积后的样品，发现沉积仅在外表面上进行，可使孔口变小但不影响孔道内性质，显示有对于二甲苯分子的择形吸附能力，且在甲苯甲醇烷基化反应和二甲苯异构化反应中表现出良好的择形催化性能．     

白血病骨髓移植病人全血微量元素铜的变化及其意义

为了研究白血病骨髓移植病人全血微量元素铜的变化及其意义 ,用原子吸收光谱法检测了正常对照组与白血病骨髓移植患者预处理前及移植后骨髓空虚期全血微量元素铜的含量。结果表明 ,正常对照组全血铜浓度与白血病骨髓移植患者预处理前全血铜浓度差异无显著性 (P >0 0 5 ) ,而与骨髓空虚期全血铜浓度有显著性差异 (P <0 0 5 ) ,说明白血病缓解后血铜接近正常对照组水平 ,而白血病骨髓移植患者预处理后骨髓空虚期全血铜含量高于正常对照组 ,说明预处理影响微量元素铜的代谢 ,本文就其影响机理进行了研究     

氨三乙酸增敏催化光度法测定痕量锰

在活化剂氨三乙酸存在下,基于锰(Ⅱ)催化高碘酸钾氧化溴酚蓝的反应,拟定了测定痕量锰的催化光度法。此催化反应灵敏度高,选择性和重现性较好,线性范围为0.4~10μg.L-1,检出限为8.5×10-8g.L-1,用于测定水样和茶叶中的锰,分析结果的相对标准偏差(n=6)分别为3.2%及1.1%,回收率依次为93%~109%和94%~108%。     

可剥离膜去除不锈钢表面铀污染的研究

退役的核设施中不锈钢制件表面附着的放射性污染物 ,必须经去污处理后才能回收利用。铀是核工业中最常见的污染放射性元素 ,而不锈钢是核设施中最常用的耐腐蚀金属材料 ,由于以ＵＯ2 +2 状态存在的铀 (Ⅵ ) ,在空气和自身的辐射作用下 ,将逐渐转变为不同的氧化物。采用酸性去污液对不锈钢表面铀污染进行浸泡和擦试去污的方法 ,可以有效的除去不锈钢表面铀污染[1] 。但因浸泡需大量的去污液 ,随之产生大量的带有放射性的废液 ,对这些废液还必须经进一步的浓缩———固化处理。擦试法虽产生固体废物 ,但去污操作麻烦 ,难以对大批量、形状复杂…     

Synthesis of gramicidin S and its analogues via an on-resin macrolactamization assisted by a predisposed conformation of the linear precursors

A simple and efficient preparation of gramicidin S and its analogues is described. It involves solid-phase peptide synthesis and on-resin macrolactamization without side chain protection, affording cyclic products in high yield and high purity. The high specificity of the cyclization reaction was shown to originate in the formation of a pre-organized conformation of the linear biosynthetic precursor of gramicidin S. This facile method will provide convenient access to the analogues of the natural product for functional optimization to counter microbial resistance.